So, I think i've encountered a problem regarding the targeting of a banshee.
I've been watching the bot have a couple of test runs, and I've seen the bot killing most banshees well.
However, sometimes when it's chasing the banshee while it's in red hp, the bot just stops and let the banshee run away. So it heals again and comes back, it's a waste of supplies.
I've been adjusting profile priorities, but can't seem to find the right slider values to solve the problem. Although, I don't that's' the cause of my problem, since the bot is even doing it when there's just 1 banshee on the screen.
Now the question is, is there something wrong with the way I set it up, or does this occur to you too?
Greetings
// Just saw I posted this in support, sorry, thought I was in the bugs section.